User manual

Imagestore User Manual Installation and Integration
Miranda Technologies Ltd Page 189
Configuration Load
This procedure uses a 3½" floppy disk, previously created using the
procedure described under "Configuration Save".
The feature loads the configuration from the floppy disk that is in the front-
panel disk drive and configures the Imagestore to conform to the settings on
the disk. Place the configuration disk in the front-panel drive and select set-
up from the start-up menu before pressing the enter key. From the set-up
menu, use the arrow keys W X to display the option file in line two of the
display and press the enter key to bring up the file menu. Use the arrow keys
W X to display the configuration load option and press the enter key to start
the loading process.
After a few moments the display will respond with a series of messages as it
sequentially loads the configuration components.
Diagnostic Save
This procedure requires a DOS formatted, 3½" floppy disk. Label the disk
"Imagestore Diagnostic" and add the serial number of the unit together with
the date.
The feature saves diagnostic data to the floppy disk that is in the front-panel
disk drive. The Miranda Technologies Ltd support team may request a copy
of this diagnostic data to assist in resolving customer queries. Place a DOS
formatted blank disk in the front panel drive and select set-up from the start-
up menu before pressing the enter key. From the set-up menu, use the arrow
keys W X to display the option file in line two of the display and press the
enter key to bring up the file menu. Use the arrow keys W X to display the
diagnostics to FDD option and press the enter key to start the saving process.