User manual

Imagestore User Manual Intuition
Miranda Technologies Ltd Page 153
Imagestore Intuition Control
The Imagestore has to be configured to operate with an Intuition. From the
front panel select:
System->Setup->Serial Comms Setup->RS232 Protocol.
When in operation the RS232 port is used to send selected commands to the
Intuition (@19.2k). The commands listed below in yellow are the ones
which will be supported.
ID: 8 Load file no. File
ID: 9 Save Image File
ID: G Set Image Position File
ID: I File save mask File
ID: O enquire image load File
ID: P Enquire File Status File
ID: R0 Load image File
ID: R1 Save Image File
ID: R2 Erase Image File
ID: 0 Fade to/from black Keyer
ID: 2 Cut to/from black Keyer
ID: 1 Fade keyer up or down Keyer
ID: 3 Cut keyer up/down Keyer
ID: 4 Set Mask Keyer
ID: 5 Mask enable/disable Keyer
ID: A Erase Store Keyer
ID: C Set key source Keyer
ID: D Set key linear or full Keyer
ID: E Set key normal or invert Keyer
ID: F Set clip grain transparency Keyer