User manual

Easysound Audio Imagestore User Manual
Page 138 Miranda Technologies Ltd
features such as audio levels to be controlled automatically by video levels to
simplify the audio-follow-video operation.
When the appropriate fader is displayed, you can:
♦ press enter to enable or disable the fader
♦ invert the polarity of the displayed fader
♦ prevent sudden jumps caused by accidental fader movements by doing a
fader pickup (the fader must be moved through the current position
before you take control)
See Analogue Faders for a complete list of al the faders which are available
with the Easysound new audio model:
Note: The list of controllable functions and the set of fader inputs available
to control them will depend on the options fitted to your version of
Imagestore.
Easysound and Easyplay external
interfaces
The following paragraphs describe:
♦ the Easysound/Easyplay external interfaces
♦ the way in which remote controllers and faders may be attached
♦ the procedure for configuring the general-purpose interface (GPI) control
ports
If you have been supplied with Easysound in kit form this section describes
the installation of the board and its driver software.
The Easysound board may be installed with Miranda Technologies Ltd's
Imagestore host units.
Configuration
When a host unit with Easysound or Easyplay installed has power applied,
the boot-up sequence includes reading the audio layer configuration from the
unit's hard disk. Whenever the configuration is changed by means of an