User manual

Imagestore User Manual Easysound Audio
Miranda Technologies Ltd Page 125
Embed OP Settings
There are two outputs from the Easysound audio mixer:
♦ programme (this is the main audio output)
♦ preview (this enables you to monitor the various audio mixes and levels
before they go to air)
You use the Embed OP Settings menu to specify the following output
settings:
Output Gain output gain enables you to specify the output
levels for pairs or groups in a range from –100dB
to +28dB
choose Pair 1 or Pair 2, press enter and then
set/adjust the embed output gain using W and X
Mute mute enables you to mute pairs or groups
choose Pair 1 or Pair, press enter then choose
Mute On or Mute Off
Embed Settings embed settings enables you to embed one of the
four audio groups in the output video (note that
the programme audio is always copied to AES
outputs 3 and 4)
choose the appropriate group (Group 1, Group 2,
Group 3 or Group 4) and press enter to embed the
settings for the chosen group
Effects Send
Effects Send allows you to select an AES output (pair 1 or pair 2) to route an
audio signal to an external special effects unit.
Use the Effects Send menu to select the following options: