User manual

Imagestore User Manual Easysound Audio
Miranda Technologies Ltd Page 123
Shuffle shuffle enables you to move mono channels
around within a group – and therefore perform
pair swaps
Mute mute enables you to mute pairs or groups
choose Pair 1 or Pair 2, press enter and then
choose Mute On or Mute Off
Trim trim enables you to boost or attenuate pairs in a
range from –6dB to +6dB
choose Pair 1 or Pair 2, press enter and then
set/adjust the input trim using W and X keys
Phase phase enables you to invert the phase of pairs or
groups
choose Pair 1 or Pair 2, press enter and then
choose normal or inverted
Level level enables you to adjust the input levels for
pairs or groups in a range from –100dB to +28dB
choose Pair 1 or Pair 2, press enter and then
set/adjust the level using W and X keys
Input Source input source enables you to choose the incoming
audio from the AES streams or the audio
embedded with the video input (choose group 1, 2,
3 or 4 or AES) – note that the input source option
is only available for VO2 (VO1 can only be used
with AES and so the input source option is not
displayed)
VO1 Settings/VO2 Settings
Audio model mode enables you to insert voice overs into your normal audio
programme. In A/B Mix and VO mode you can insert two stereo pair voice
overs into the mix. In Two Voice Over mode you can insert four stereo pair
voice overs into the background or programme audio. Each voice over has
two parameters which need to be set - duck level and VO level (these are
described below).
You use the following menu to specify the VO1 and VO2 settings (note that
VO2 Settings is not available in AB Mix and VO mode):