User manual

Easysound Stand-alone User Manual Common Commands
Miranda Technologies Ltd Page 65
The alternative to a common analogue reference source is to use the
background SDI signal as the source of timing. This may be more suitable
where the unit is used within a simple presentation system.
The current setting (Analogue (Black and Burst) or SDI Bgnd) is enclosed in
brackets. To change the setting, use the arrow keys W X to display the new
setting and press the enter key to apply it.
Reference timing
When the Reference timing option is displayed you can adjust the timing
from –7 lines 63.703uS to +7 lines 6.3 703uS.
Serial comms setup
When the Serial comms setup option is displayed you can view or change the
Protocol (RS-232 or RS 422) or baud rate (19200, 38400, 57600 or 115200).
The current setting is enclosed in brackets. To change the setting, use the
arrow keys W X so that the new setting is shown within the brackets and
press the enter key to apply the selection.
RCP Mirror
The RCP Mirror option enables you to disable or enable it.
Restart System
To re-boot the unit without removing the power (a warm re-boot), use the
arrow keys W X so that the brackets enclose the YES option and then press
enter again.
Clean Restart
The clean restart feature provides for the erasure of all configuration file
settings and returns Easysound Standalone to the original factory settings.
Video (and audio) GPI settings and all image files are retained.
To clean restart the unit, use the arrow keys W X so that the brackets enclose
the YES option and press enter again.