User manual

Easysound Stand-alone User Manual Common Commands
Miranda Technologies Ltd Page 61
blank DOS formatted disk and place the disk in Easysound Standalone’s
FDD.
Installing system codes
To install system codes from a supplied floppy disk:
♦ insert the floppy disk in the Easysound Standalone floppy drive
♦ choose Load System Codes from the Setup/File front-panel menu
To install system codes from an email file (syscodes.txt):
♦ transfer the email file (syscodes.txt) to a blank DOS formatted floppy
disk
♦ insert the floppy disk in the Easysound Standalone floppy drive
♦ choose Load System Codes from the Setup/File front-panel menu
To create and install system codes:
♦ create a file called syscodes.txt (using a text editor)
♦ edit the file to include the required entry/entries from the list below and
then transfer the file to a floppy disk
♦ insert the floppy disk in the Easysound Standalone floppy drive
♦ choose Load System Codes from the Setup/File front-panel menu
The SYSCODES.TXT file can include one or more of the following entries:
IP_ADDRESS sets up the machine’s IP address (for Ethernet
access via Miranda Technologies Ltd’s MDS
system)
SUBMASK sets up the machine’s IP submask (for Ethernet
access via Miranda Technologies Ltd’s MDS
system) default = 255,255,0,0
HOSTNAME sets up the machine’s host name – this name is
displayed on the root menu of the Oxtel RCP
panel and on the front-panel scrolling screen (note
that this command is not currently used for
Ethernet naming)
GATEWAY set the machines gateway address,
default= 0 0 0 0