User manual

Easysound Stand-alone User Manual Common Commands
Miranda Technologies Ltd Page 55
Faders Setup
Up to 8 external faders (potentiometers) may be connected thought the rear
panel AES Control Port of the Easysound Standalone and a further 8 through
the SDI Control port. These faders are used to manually control the rate at
which the Easysound Standalone will execute a command and will override
settings made through the front panel.
Analogue faders may be used to control fades and mixes. A resistive (linear)
potentiometer of at least 10KΩ should have its fixed terminals connected
between pin 7 (+5V) and pin 15 (Ground). The variable output of the pot
should connect to the appropriate fader input pin.
Screened cable should be used to connect the fader to the Easysound
Standalone and the screen of the cable should only be connected to ground at
the Easysound Standalone end of the cable to avoid earth loops, and to
restrict extraneous signal levels to less than 1 mV.
The Faders Setup menu includes the following options:
Audio A/B Mix
Output Level
FTS Level
VO 1 Pr 1 and Pr 2 Level
VO 1 Pr 1 and Pr 2 Pset
VO 1 Pr 1 and Pr 2 Duck
VO 2 Pr 1 and Pr 2 Level
VO 2 Pr 1 and Pr 2 Pset
VO 2 Pr 1 and Pr 2 Level
A and B Input Level
VO Input Level
A and B Input Trim
VO Input Trim
Each option is described in the following sections: