User manual

Easysound Stand-alone User Manual AES 6 Channel Mode
Miranda Technologies Ltd Page 39
AES 6 Channel Mode
To select AES 6 Channel mode go to Set-up/System/Audio Control then press
the enter key. Use the arrow keys W X to select AES 6 Channel then press
enter. Reboot the unit if instructed.
AES 6 Channel mode is intended for Presmaster and Imagestore installations
where full AB audio mixing of decoded base band 5:1programming is
required. The two base band 5:1 programmes (A and B) are connected to the
Easysound Standalone as AES inputs 1 through 3 (A) and AES inputs 4
through 6 (B). The mixed output is available on AES outputs 1 through 3.
AES output 4 is always silent. (For full connector details see the
Configuration and Set-up section of this manual.)
Connectivity between an Imagestore 2/3 and Easysound Standalone is via a
loop through RS422 lead (see illustration above). Simultaneous control of the
units is then achieved by Presmaster or Automation. For independent control
select Ignore Preselect from the front panel (see page 42).