Instruction manual

GUIDE TO INSTALLATION AND OPERATION
FIO-1901-RR | 1
1 FIO-1901-RR 3G/HD/SD Fiber Optic to Electrical Converter
1.1 Introduction
The FIO-1901 series are flexible serial digital video To/From Fiber Optic converters for the Densité frames. The FIO-
1901 series are designed for SD, HD and 3G serial video as well as compressed bit-streams (DVB-ASI). The series
supports any data rate within the range of 19.4 Mbps to 2.97 Gbps and provides a reclocked serial digital video from
270Mbps to 2.97 Gbps. The FIO-1901 series offer five different configurations: Single or dual fiber Tx, single or dual
fiber Rx and a bi-directional fiber Rx/Tx. The series is based on SFP modules that provide easy product maintenance
and flexibility when multiple wavelengths are needed (as for CWDM). The SFP Modules are also hot-swappable.
The FIO-1901 can be installed in the same chassis as a series of interface modules, providing a wide variety of video,
audio and data conversion and multiplexing functions.
The FIO-1901-RR version incorporates dual optical receivers, and is also available in a WDM version for use with a
single optical fiber.
1.2 Features
• Supports any serial data rate from 19.4 Mbps (ATSC) to 2.97 Gbps (3G SDI)
• Reclocked serial digital video for 270 Mbps, 1.49 Gbps, and 2.97 Gbps
• Provides unidirectional interface between fiber optic and serial digital
• Supports Multiple wavelength from the standard 1310 nm, 1550 nm to multiple CWDM wavelengths
• WDM (1310/1550) solution for dual Rx cards
• Possible to set the Dual Rx modules in a changeover mode.
• Ideal for long video run with “Hum” immunity
• Presence/loss of signal alarm – iControl, on-board LED and Densité Control Panel
• SFP Optical power monitoring and report
• Internal SFP temperature alarms on the iControl interface and on the Densité Control Panel
• SFP Module type detections and report mismatch
• Remote monitoring and control
• Convenient front loading design
• The cards and the SFP modules are fully hot swappable