Specifications

ENC-1103 SDI to Composite/CAV/RGB Encoder
Guide to Installation and Operation
ENC-1103 Page 5 of 19
Audio Processing tab
Group Detected: highlights the AES audio groups detected in the
input signal.
CH1,2,3,4, and CH 5,6,7,8: select the AES group to be used as
source for channel 1 to 4 and 5 to 8.
Output tab
These controls allow the selection of the different output formats
and parameters.
OUTPUT FORMAT: NTSC, PAL-M, GBR, YUV, BETACAM (for
525) or PAL, GBR, YUV, BETACAM (for 625): Sets the video
output type.
VIDEO SETUP: O IRE, 7.5 IRE: In 525 lines operation, enables
or disables 7.5 IRE units set-up on the output NTSC video signal.
H BLANKING: WIDE, NARROW: Sets the value of the horizontal
blanking interval.
CLOSE CAPTION: In 525 lines operation, check the box to enable
7.5 IRE units set-up on line 21 of the output NTSC video signal.
GAIN: -75, -74, …, 74, 75: Sets the value of the overall output gain;
this gain modifies the amplitude of the analog video signal
amplification.
COLOR BARS: check the box to select a 75% color bar test signal
at the output.