Specifications

ENC-1103 SDI to Composite/CAV/RGB Encoder
Guide to Installation and Operation
Page 4 of 19 ENC-1103
User Presets – the buttons at the bottom left control the
saving and recovery of sets of user-defined card
configurations
Profiles – the Profiles button opens a panel that allows the
entire card set-up to be copied to other ENC-1103 cards
All of the individual control panels are described in detail
below.
Panel See Page
Video Processing................................................4
Audio Processing................................................5
Output.................................................................5
Thumbnail...........................................................6
Blanking..............................................................6
Timing.................................................................7
Reference Input ..................................................7
Input Error...........................................................8
Options ...............................................................8
ABUS..................................................................9
Factory..............................................................10
Alarm Config.....................................................10
Info....................................................................12
User Presets.....................................................14
Profiles..............................................................14
Video Processing tab
These controls reflect the type of output selected: NTSC or PAL-M
(composite), GBR, YUV or Betacam.
ALL GAIN: -800, -799, …, 799, 800: Sets Luma and Chroma gains
to a specific value. When others gains are individually set, ALL
GAIN reflects the average value of the combined gains for a given
output format.
LUMA GAIN: -800, -799, …, 799, 800: In Composite mode, sets
Luma gain to a specific value.
CHROMA GAIN: -800, -799, …, 799, 800: In Composite mode,
sets Chroma gain to a specific value.
G GAIN; B GAIN; R GAIN: -800, -799, …, 139, 140: In RGB
mode, sets the gains for the individual components of the video
signal to a specific value.
Y GAIN; B-Y GAIN; R-Y GAIN: -800, -799, …, 799, 800: In YUV
and BETACAM mode, sets the gains for the individual components
of the video signal to a specific value.
HUE:-180, -179, …, 179, 180: Sets Hue to a specific value in
degrees.
BLACK LEVEL: -100, -99, …, 99, 100: In NTSC mode, sets Black
level to a specific value.
PRE FILTER: OFF, ON: In NTSC mode, applies a line comb
pre-filter to the video input signal.