Instruction manual

GUIDE TO INSTALLATION AND OPERATION
50 | IRD-3111
5 Specifications
8VSB/QAM INPUT (IRD-3111-VQ only)
Quantity/connector: One input with F-type connector, 75 ohm
Tuning range: 51 MHz-858 MHz
Input level: -27 dBmV to +33 dBmV
QPSK/8PSK INPUT (IRD-3111-DVB-S2 only)
Quantity/connector: One input with F-type connector, 75 ohm
Demodulation: DVB-S (QPSK) ETSI EN 300 421
DVB-S2 (QPSK/8PSK) ETSI EN 302 307
Tuning range: 940 to 2150 MHz (in 0.5 MHz steps)
Symbol rate range: DVB-S: 2 to 45 MSymbols/s
DVB-S2: 10 to 30 MSymbols/s
Input level: -25 dBm to -65 dBm
ASI INPUT
Quantity/connector: One input with BNC connector
Standards: EN50083-9 (V2:3/98) DVB ASI
Data bit rate: DVB ASI: Up to 80 Mbps
Mode: Burst and byte supported
TS packet length: 188/204 byte packets
Return loss: >15 dB up to 270 MHz
ASI OUTPUT
Quantity/connector: One output with BNC connector
IP OUTPUT
Quantity/connector: One Gigabit Ethernet with RJ45 connector IEEE 802.3
Standards: Pro-MPEG Code of Practice 3 (CoP3)
Stream protocols: IP/UDP, RTP and IGMPV3
VIDEO DECODER
Compatibility standard: H264/AVC
MPEG-2 compatible MP@H
4:2:0, resolution up to 1080i, 59.94 Hz
ATSC A/53
Dual Dolby Digital passthrough
Bit rate: Up to 25 Mbps
AUDIO DECODER
Standard: MPEG-1 layer-II
Dolby Digital (AC-3) audio 2.0
Optional Dolby Digital (AC-3) audio 5.1
AAC audio 2/0 and 1/0
Service/channels: As per ATSC A/54A
VIDEO OUTPUTS
SD SDI outputs: Two outputs with BNC connectors
Signal: SMPTE-259-C (270 Mbps)
SMPTE 292M (1.485, 1.485/1.001 Gbps)