Instruction manual

GUIDE TO INSTALLATION AND OPERATION
14 | IRD-3111
3.4.2 The Input panel
This panel provides resources for input configuration and
monitoring.
Input section
Use the Desired radio buttons to select the input. Available
options are:
• ASI1 – ASI input
• Tuner – The built-in ATSC or DVB-S/S2 tuner
• Ethernet – the data stream arriving on the rear-panel
Ethernet port (only available when it is in Input mode)
• AUTO – select the first valid input, prioritized as listed
here (i.e. ASI1, Tuner, Ethernet)
The Selected and Presence icons show which input is
currently selected, and which ones are currently available.
Auto Switch Delay
Use the slider, or type a value directly into the data box, to
set the time the card will wait before switching automatically
to another valid input if the current TS signal fails.
Output on Error
Use the radio buttons to set the behavior of this IRD-3111 in the event of an input signal error.
• Black – switch the output to black
• Freeze – freeze the output on the last valid frame
TS Input Type – this box reports the transport stream type.
TS Limit Errors – the box lists any limit errors detected in the transport stream
Figure 3.3 The Input panel