Datasheet

Cautions
[Maintenance]
If any of following occurs, unplug the LCD TV and contact your distributor or appointed technician to
repair the LCD TV:
1. The power cord or plug is damaged.
2. Liquid enters the LCD TV.
3. LCD TV is damp or wet.
4. LCD TV is damaged.
5. LCD TV malfunctions.
DO NOT attempt to repair the LCD TV by yourself. There are high voltages inside the cabinet
which poses a risk of electric shock.
Changing parts
If the LCD TV requires new parts, ask for written proof of these required parts from the appointed
technician.
Safety inspection
After the LCD TV is repaired, remember to ask the technician to conduct a routine safety inspection
(based on the manufacturer’s requirements) to make sure the LCD TV is safe.
If the LCD TV has been used longer than its life, please contact qualified technician for repair.
[User's record]
You can find the serial no. and model tag on the back of the LCD TV. Do provide the serial no. when
you contacting the distributor or appointed service personnel.
Please read and comply with all warnings and instructions in the manual . Failing to do so may
void the warranty. Modifying the LCD TV in any unauthorised manner will void the warranty
immediately.
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception which can be determined by turning the equipment off and on the user is
encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna
* Increase the separation between the equipment and receiver
* Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected
Caution: To comply with the limits for an FCC Class B computing device, always use the signal cord
and power cord supplied with this unit. The Federal Communications Commission warns that changes
or modifications to the unit not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
European Notice
Products with the CE Marking comply with both the EMC Directive (89/336/EEC), (93/68/EEC) and
the Low Voltage Directive (73/23/EEC) issued by the Commission of the European Community.
04 ................................................................................................................................................................