System information

Assembly of Centerline
Collapsible Pilot Chute
Pass the white collapse line and the bridle through the
Rapid link by passing them through the open gate of the
link. At this point, a small screwdriver or other similar
tool can be used to straighten out the second fabric
loop [Fig. 4]
Feed the male end of the connector link through the
gap in the second loop until it protrudes through the
loop, the thread the barrel over the male end, closing
the link. Tighten lightly with a wrench [Fig. 5]
Now pull the loop material over the barrel so the barrel
is covered by the black loop. The collapse line should
exit the bridle between Kevlar and the link should lie as
shown [Fig. 6]
Fig. 4
Fig. 5
Fig. 6