System information

Assembly of the 3-Ring
Release System
Before assembling the 3-Ring release,
make sure the risers aren’t twisted or
reversed. Lay the Mirage face down,
as you would to pack it. Thread each
cable into its housing and mate the
handle to the harness. The handle
should be positioned as close to the
ends of the housings as possible so
that no cable is exposed.
With the rings of the riser facing forward, pass the
large ring on the end of the riser through the large
harness ring from above. Fold it back toward the
canopy and risers. [Fig.1]
Thread the smallest ring through the middle ring in the
same way, but make sure it doesn’t pass through the
large ring. [Fig. 2]
Fig. 1
Fig. 2