SDS

MSC-013 - Grout Shield
Revision Date: 30-Jul-2016
_____________________________________________________________________________________________
_____________________________________________________________________________________________
Page 2 / 6
4. FIRST AID MEASURES
First Aid Measures
General Advice
Provide this SDS to medical personnel for treatment.
Eye Contact
Flush immediately with clean, free-flowing water for 15 minutes. Consult a physician if
irritation persists.
Skin Contact
Remove wet clothing and launder before re-use. Wash thoroughly with soap and water
affected area.
Inhalation
Remove person to fresh air. If not breathing, administer artificial respiration including
oxygen. Provide medical attention.
Ingestion
Do not induce vomiting. Never give anything by mouth to an unconscious person. Rinse out
mouth with clean water. Get medical attention.
Most important symptoms and effects
Symptoms
EYES: Mild eye irritant. Direct contact with the solution may cause slight iridal and
conjunctival irritation. No permanent damage is anticipated.
SKIN: Can be mildly irritating upon prolonged exposure (liquid stage only).
INGESTION: Can cause gastrointestinal irritation, nausea, vomiting and diarrhea.
INHALATION: Gross over-inhalation may cause symptoms such as, but not limited to,
coughing. May aggravate pre-existing lung disorders.
Indication of any immediate medical attention and special treatment needed
Notes to Physician
Treat symptomatically.
5. FIRE-FIGHTING MEASURES
Suitable Extinguishing Media
Water, CO2, Dry Chemical, Foam.
Unsuitable Extinguishing Media
Not determined.
Specific Hazards Arising from the Chemical
Product is not flammable or combustible.
Hazardous Combustion Products Carbon oxides.
Protective equipment and precautions for firefighters
As in any fire, wear self-contained breathing apparatus pressure-demand, MSHA/NIOSH (approved or equivalent) and full
protective gear.
6. ACCIDENTAL RELEASE MEASURES
Personal precautions, protective equipment and emergency procedures
Personal Precautions
Use personal protective equipment as required.
Methods and material for containment and cleaning up
Methods for Containment
Prevent further leakage or spillage if safe to do so.
Methods for Clean-Up
Collect any spills with absorbent material such as vermiculite, place collected material in a
polyethylene lined metal container and seal. Clean up residue with water. For waste
disposal, see section 13 of the SDS.