Installation Manual

UNDERCOUNTER INSTALLATION
• C ut out the opening by carefully following the
pencil line traced from the template.
NOTE: The screws and anchor s provided
should be used on countertops with a
minimum 1” (2.5 cm) thickness. For thinner
countertops, use appropriate anchors and
fasteners (not provided).
For Wood Countertops
• Mark and pre-drill the wood screw holes at
the locations shown on the template.
• Waterproof any exposed areas of wood.
For Marble/Stone Countertops
• Po
sition the countertop upside down on foam
padding to protect the surface. Mark and drill
3/8” holes 5/8” (1.6 cm) deep at the
locations shown on the template.
• Use a setting tool and hammer to secure
the anchors.
For All Undercounter Installations
• If the countertop has not been installed,
install it at this time.
• Drill the faucet holes according to the faucet
installation instr uctions.
• Install the faucet to the countertop according
to the faucet manufacturer’s instruc
tions.
• Install the drain to the lavator y according to
the drain manufacturer’s instructions.
NOTE: Do not use adhesive s or adhesive
sealants.
• Apply a continuous bead of quality sealant
to the top sur face of the lavatory rim where it
will contact the countertop.
• For marble countertops, install the lavatory
to the countertop with the clamps and screws
provided. For other countertop materials,
refer to the countertop manufacture r’s
instructions for re commended fast
eners.
• Position the lavatory squarely under the
cutout before tightening the clamps. Draw
the lavatory rim up against the countertop
until it is snug. Do not overtighten.
• Immediately wipe away any excess sealant
and fill any voids as needed.
• Allow the sealant to set for 30 minutes before
proceeding.
• C onnect and tighten the trap to the drain,
and complete the water supply connections to
the faucet according to the instructions
packed with the faucet.
• Run water into the l
avatory and check for leaks.
• C lean up with a non-abrasive cleaner.
CAUTION
Risk of personal injury or
product damage.
Handle with care. Product can break,
chip or cause injury if handled carelessly.
Get help lifting the lavatory.
43
Apply sealant
Wood
screw
Cl amp
Setting tool
Anchor
Foam paddi ng
M arble
Anchor
screw
CARE AND CLEANING
• To keep your lavatory looking new, make sure
you rinse it out thoroughly after each use.
• Stubbor n stains, paint, or tar c an be
removed with turpentine or pain t thinner.
CAUTION
Risk of product damage.
DO N OT use strong abrasive cleaners, as
they will scratch and dull the surface.
sensible sophistication sensible sophistication