User guide

25
Concealing Plate
Concealing Cap
Grubscrew
Control
Knobs
Concealing Ring
8. Ret or replace the lters and reassemble in
reverse order.
9. Restore the water supplies and check for
leaks.
Built in Models
1. Isolate the hot and cold water supplies.
2. Turn on the ow control knob to relieve water
pressure and to drain any residual water.
3. Return the ow control knob to the off position
and carefully remove the concealing cap.
4. Unscrew the grubscrew using a 2.5 mm
hexagonal key (supplied) and pull off the
control knob(s).
5. Carefully unclip and remove the concealing
plate from the backplate.
Note! Use a screwdriver in the cutout to assist
separation.
6. Unscrew the filter caps with the ‘O’ key
(supplied) or a 12 mm hexagonal wrench and
remove the lters.
Note! Use pliers to assist if necessary.
‘O’ key
Filter Cap
Filter
7.Clean each of the lters under a jet of water to
remove any lodged particles.
8. Ret or replace the lters and tighten the lter
caps.
Note! Make sure that the seal is tted correctly
and not damaged.
9. Turn on the hot and cold water supplies and
check for leaks.
10. Reassemble all other parts in reverse order.
Lubricants
Silicone based lubricants must only be used on
the rubber seals.
Caution! Oil based or other lubricant types may
cause rapid deterioration of seals.
Cleaning
The chrome plated parts should be cleaned using
a mild washing up detergent or soap solution,
rinsed and then wiped dry with a soft cloth.
Warning! Many household cleaners contain
abrasive and chemical substances, and should not
be used for cleaning plated or plastic ttings.
Do not use descalents on this product.
In-service Tests
The principal means for determining the continuing
satisfactory performance of the mixing valve is the
in-service test, refer to the TMV2 Requirements
Manual.
Frequency of In-service Tests - Commercial
(non-domestic installations)
Check for correct blend setting every 6 months.
ACCESSORIES
Genuine Mira accessories can be purchased
direct from Mira Customer Services (our contact
details can be found on the back cover of this
guide) or from approved stockists or merchants.
Adjustable Elbow Pack
Chrome - 1.1663.012
The Mira Adjustable Elbow Pack allows the Mira ‘mini
valves’ to be retro-tted in place of an existing shower
- no need to re-plumb or re-tile.