User guide

9
23 mm from nished
wall surface
Elbow
Recess Ø19 mm
x 2 mm deep
23 mm
110 mm
HOT
COLD
6. Reverse Inlet Supplies Only:
a) Using a suitable tool, carefully remove the
plug cap from the centre of sealing plug
to reveal keyway.
b) Remove the sealing plug using the ‘O’ key
(supplied) or a 12 mm hexagonal key.
c) Carefully remove the ow regulator from
the outlet nipple, then remove the outlet
nipple using the ‘O’ key (supplied) or a
12 mm hexagonal key.
d) Ret the sealing plug and outlet nipple in
the opposite outlets and tighten.
Note! Make sure that the ‘O’ seals are
correctly tted.
e) Ret the ow regulator, make sure that it
is tted correctly, refer to illustration.
f) Rotate the mixer 180°.
g) The control knob(s) will have to be
realigned, this can be completed in
section: ‘Commissioning’.
Plug Cap
Sealing Plug
‘O’ Seal
Outlet Nipple
Flow Regulator
7. Remove the backplate from the mixer by
loosening the grubscrew with a 2.5 mm
hexagonal key (supplied).
8. Secure the backplate to the wall using the
screws (supplied).
Screw
Backplate