User guide

5
SPECIFICATIONS
Pressures
Max Static Pressure: 10 Bar.
Max Maintained Pressure: 5 Bar.
Min Maintained Pressure (Gravity System):
0.1 Bar. (0.1 bar = 1 Metre head from cold
tank base to shower handset outlet).
Note! For gravity fed / other low pressure
systems (0.5 bar or below) remove the ow
regulator(s).
For optimum performance supplies should be
nominally equal.
Temperatures
Factory Pre-set (Blend) Shower: 43°C.
Optimum Thermostatic Control Range: 35°C
to 43°C (achieved with supplies of 15°C cold,
65°C hot and nominally equal pressures).
Recommended Hot Supply: 60°C to 65°C
Note! The mixing valve can operate at
higher temperatures for short periods without
damage, however this could detrimentally
affect thermostatic performance. For safety
and performance reasons it is recommended
that the maximum hot water temperature is
limited to 65°C.
Cold Water Range: up to 25°C.
Minimum Recommended Differential between
Hot Supply and Outlet Temperature: 12°C.
Thermostatic Shut-down
For safety and comfort the thermostat will
shut off the mixing valve within 2 Seconds if
either supply fails. (achieved only if the blend
temperature has a minimum differential of
12°C from either supply temperature).
Connections
Inlets: 15 mm Compression.
Outle t: ½ BSP Flat F ace / 1 5 mm
Compression
Standard connections are: hot - left, cold
- right, outlet - bottom (EV models), top
(BIV models).
Flow Regulators
Site conditions and thermostatic mixer model will
determine the ow regulator requirements.
For gravity systems (0.5 bar or below) remove the
inlet and outlet ow regulators (where tted).
Model Cold Inlet Outlet
Moto
ü
(supplied tted in
the outlet nipple)
Pace
ü
ü
(supplied tted in
the outlet nipple)
Minilite EV
ü
(supplied tted in
the outlet nipple)
Minilite BIV
ü
(supplied in the
component pack)
Miniduo EV
ü
ü
(supplied tted in
the outlet nipple)
Miniduo BIV
ü
ü
(supplied in the
component pack)
Flow Regulator Removal
Inlet Flow Regulator
Inlet Elbow
Nipple
Outlet Flow Regulator
Grubscrew