User guide

14
20. Remove the assembly from the wall and
separate the backplate from the wallplate.
21. For solid walls drill two 6 mm holes for the
wall plugs. For other types of wall structure
alternative fixings may be required (not
supplied). If necessary, make a recess 6 mm
deep to accept the wallplate for ush tting of
the outlet to the wall surface.
Caution! Make sure that you do not drill into
pipework in the wall.
22. Fit the two wall plugs supplied and secure
the wallplate to the wall with the two wallplate
screws.
23. Make sure that there is clearance behind the
wallplate and temporarily t the two backplate
screws into the wallplate. This will prevent
the xing holes from becoming blocked with
plaster or grout.
24. Finish the wall, e.g. tiles. then remove the two
backplate screws.
Important! Make sure that you use the
cardboard building-in shroud when nishing
the wall. This will protect the valve and make
sure that you tile up to the correct diameter.
Cardboard
Building-in Shroud
Caution! Make sure that the nished wall is
within the maximum and minimum limits and to
an even depth (no greater than 2 mm variation)
or the controls will not t correctly.
25. Place the backplate over the outlet pipe with
the arrow pointing vertically up and tighten the
two backplate screws. Make sure that the foam
seal abuts the nished wall surface.
26. Check that the ‘O’ seal is tted inside the
backplate nut. Fit the olive and the backplate
nut over the outlet pipe and tighten the nut.
27. Check that the second ‘O’ seal is tted to the
outside of the backplate nut. Press the elbow
onto the backplate, make sure that the clips
on the elbow engage with the backplate.
28. Press the shroud over the elbow, make
sure that it engages with the lugs on the
backplate.
Backplate Nut
Olive
Elbow
Shroud
29. Fit the concealing ring over the mixer and mark
the positions of the three xing holes.
30. For solid walls drill three 6 mm holes for the
wall plugs. For other types of wall structure
alternative fixings may be required (not
supplied).
Caution! Make sure that you do not drill into
pipework in the wall.
31. Insert the wall plugs (supplied) and attach the
concealing ring to the wall with the screws
provided.
Important! Apply silicone sealant to the
groove on the rear face of the concealing
ring