User guide

10
9. For Rear Entry Supplies Only:
a) Fit the concealing plates over the inlet
pipes.
Note! Apply silicone sealant to the back
face of the ange.
Apply Silicone Sealant
Concealing Plate
10. Caution! It is essential at this point that the
supply pipework is thoroughly ushed through
before connection to the mixer. Failure to do
so may result in product malfunction.
11. Fit the compression nuts and olives onto the
pipework.
12. Align the mixer with the pipework and t onto
the backplate.
Important! Make sure that the hot and cold
inlets on the mixer correspond with the hot and
cold inlet supplies.
13. Tighten the compression nuts onto the mixer
with a suitable spanner.
Caution! Take care not to damage the chrome
surfaces.
14. Tighten the grubscrew to secure the mixer to
the backplate.
Olive
Compression Nut
15. Fit the shower ttings, refer to your shower
fittings installation and user guide for
instructions.
Important! A 12 litre/minute ow regulator
is tted inside the outlet nipple. This can be
removed for gravity fed / other low pressure
systems (0.5 bar or below), refer to section:
‘Specications,FlowRegulators’.
16. Turn on the hot and cold water supplies and
check for leaks.
17. Before using the shower, refer to section:
‘Commissioning’.