User guide

ManualsBrandsMipro ManualsConsumer electronicsACT-7H

Design and specifications are subject to change without prior notice

User Guide

ACT-7H Handheld Transmitter

MIPRO Electronics Co., Ltd.

Headquarters: 814 Pei-Kang Road, Chiayi, 60096, Taiwan.

Web: www.mipro.com.tw

E-mail: mipro@mipro.com.tw

AS110215

2 CE3 7 4 B

Summary of content (5 pages)

PAGE 1
ACT-7H Handheld Transmitter User Guide MIPRO Electronics Co., Ltd. Headquarters: 814 Pei-Kang Road, Chiayi, 60096, Taiwan. Web: www.mipro.com.tw E-mail: mipro@mipro.com.
PAGE 2
Handheld Transmitter Handheld Transmitter KEY FEATURES: PART NAMES AND FUNCTIONS  Rugged magnesium alloy construction. 1 2  Patented rear housing design protects accidental power on/off and built-in antenna from breakage. 4 3 5 6 GROUP CHANNEL BAT  Bright LCD display shows group, channel, battery status and error code.  Ten different rear caps to visually identify a particular microphone channel on stage.
PAGE 3
Handheld Transmitter Handheld Transmitter BATTERY INSTALLATION PROPRIETARY DESIGN TO AVOID ACCIDENTAL POWER ON/OFF 4 The protective handheld cap prevents accidental power on/off and protects internal components. REMOVE HANDHELD TRANSMITTER CAP: (Figure 2) 1. Unscrew lower housing direction. 4 in counter-clockwise 2. Insert two 1.5 Volt (AA) batteries into the battery compartment according to the correct polarity as shown in Figure 2.
PAGE 4
Handheld Transmitter Handheld Transmitter BATTERY STATUS LCD SCREEN GROUP CHANNEL BAT ERR ! ERR Message: When “ERR” appears in the display it indicates that an operational error has occurred. Please refer to the following codes to diagnose which error you are experiencing. ERR no01 EEPROM is not being programmed or internal data error. ERR no02 For testing only. ERR no03 The frequency you want to program is above the switching bandwidth of the transmitter.
PAGE 5
Handheld Transmitter Handheld Transmitter CAUTIONS ! ! ! & IC - ID The ACT-7H has an integrated antenna at the end of the rear housing (covered by the color protective cap). Performer should avoid holding the microphone over or near the antenna section as this will deteriorate transmission efficiency. Severe deterioration if performer directly covers up the antenna section with both hands. Many performers tend to hold the microphone by the top grille.