Owner's manual

ANT.B

PART NAMES AND FUNCTIONS

0dB

+10dB

-6dB

SQLEVEL

(Figure 2)

Rear Panel

Wireless IR Remote Control Receiver

DC Input Jack: For 12V DC power input connection. Connects center pole to positive

voltage.

Antenna B Input Connector: To install the antenna B.

Unbalanced Output Socket: Unbalanced 1/4” phone jack audio output. Three level

switches:〝-6dB〞、〝0dB〞、〝+10dB〞.

Unbalanced Level Switch: At〝0dB〞level output equals to cabled microphone. At

〝+10dB〞level, it is AUX volume output. At 〝-6dB〞 level, the volume output is half

of cabled microphone.

SQ: Squelch adjustment. Adjusts receiver sensitivity to mute audio output from the

speaker when no microphone signals are present.

Antenna A Input Connector: To install the antenna A.

ANT.A

ACT-101 External ACT Port Receiver

PART NAMES AND FUNCTIONS

Wall Mount :

Front Panel

ACT-101

ACTPOWER

EXTEND

13 14 15

(Figure 3)

POWER Indicator: Indicates power status. An illuminated indicator denotes receiver

has received IR signal and now turned on.

ACT Port: Receive signal to turn on (and off) receiver and sync frequency to

transmitter.

EXTEND Socket: Connect enclosed RJ-11 network cable to same EXTEND

location of the main ACT-101 receiver.

NOTE: The purpose of installing an ACT-101 External ACT Port Receiver is to improve

infrared transmitting & reception signal quality for powering on & off the receiver as

its path maybe shielded or blocked. For example, if the main receiver is installed

inside an enclosed rack case, room or similar environments. It can be wall mounted

or stand alone.