NSA Read these Instructions. Keep these Instructions. Head ail wakings. Follow gil Instructions. Do not use this apparatus sens water Clean only with a dry cloth. Ba nat black any ventilation openings. Install in accordance with the manufacturer's instructions. Do not install near any jest sources such 35 radiators, jest registers, stoves, or notifier apparatus (Including spitfires) that produce heat.
Federal Communication Commission Interference Statement This equipment has been tested and fauns to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules, These limits are designed to provide reasonable protection against harmful Interference In a residential Installation. This equipment: generates, uses and can radiate radio frequency energy and, If not Installed and used In accordance with the Instructions, may cause harmful Interference t radio communications.
Key Features & Benefits 1. Popularized design for easy set-up, operation and maintenance. 2. Preset with 16 delectable channels. 3. Bright LED channel display. 4. Direct output for low level or switch to wide band amplifier for high level output. 5. Electable Input audio signal level for optimal modulation index. 6. Audio input and RF output LED indicators.
Controls and Indicators Rear Panel: £3) Low Power RF Quip Connector: Connect directly to a transmitting antenna or extend to external antenna by RF cable. © RF Output Switch: High or Low RF label switch. © High Power RF Output Connector: Connect directly to a transmitting antenna or extend to external antenna by RF cable. © AF Lave! Switch: audio output for optimal modulation index. $ Combs Jack Connector: Balanced DLR) or unbalanced audio input signals.
Transmitter Frequency Set-Up Press the Channel button for a clear channel. 186 preset delectable channels. Volume Limit Indicator wil not be illuminated under normal Input signals. Volume Limiter Indicator © will be illuminated if over normal Input signals. Reduce volume to desired level. Operating Tips The transmitter functions when the module and antenna are inserted properly and powered on. Ascertain the frequency code sticker is the same between the transmitter and receiver.
Insert and Remove the Module Proper RF Output Level and Output » Remove the front cover plate. Conn actor Settings » Insert MYS-100 module gently inch slot « High or Low RF level switch is located at the horizontally. rear panel. Front panel well display current High « Fasten the panel with the attached two screws. or Low RF output power setting. » To remove, reverse the above steps. « RF power will output from LOW-POWER £3 TNC connector when "LOW" setting Is selected.
Proper AF {audio) Input and Connection » Combo jack connector accepts balanced (XLR) or unbalanced cable. » Proper Input volume adjustment Is needed after AF signal Is connected. » Three delectable AF levels can be selected from AF Level Switch § for optimal audio sensitivity. Exceeding Input volume will result In distortion for receiver AF output, and insufficient input volume will degrade the S/N ratio that increases higher background nose. RF, proper setting ensures optimal output audio quality.
