IMPORTANT SAFETY INSTRUCTIONS Read these Instructions aap these Instructions. Head 81 wakings. Fallow ai Instructions. Do not use: this apparatus near water. Clean only with a dry cloth. Do not block any ventilation openings. Install In accordance with the manufacturer's instructions. Do not install! near any heat sources such as radiators, heat registers, stoves, or other apparatus {including amplifiers) that produce heat.
Key Features & Benefits 1. Popularized design for easy set-up, operation and maintenance. 2. Preset with 16 delectable channels . Bright LED channel display 4. Direct output for low level or switch to wide band amplifier for high level output. 5. Electable Input audio signal level for optimal adulation Index. 6. Audio input and RF output LED indicators.
Controls and Indicators Low Power RF Output Connector: Connect directly to a transmitting antenna or extend to external antenna by RF cabin. 0 RF Output Switch: High or Low RF level switch. © High Power RF Output Connectors Connect directly to a transmitting antenna or extend to external antenna by RF cable. © AF Level Switch: audio output for optimal modulation index. 0 Combs Suck Connectors Balanced (XLR) or unbalanced audio input signals.
Transmitter Frequency Set-Up Press and hog Channel button (D for 2 seconds until numeric LED Blinks continuously te denote it is ready for changing channel, During blinking, press and release the Channel button until one of the 16 preset channels is selected. If Channel button Is not pressed within 6 seconds during blinking the current numeric channel remains the same. Volume Limit Indicator © will not be Ruminated under normal input signals.
insert and Remove the Module Proper RF Output Level and Output « Remove the front cover plate. Connector Settings « [Insert MT-90 module gently into slot « High or Low RF level switch is located at the horizontally. rear panel. Front panel will display current High « Fasten the panel with the attached two screws. or Low RF output power setting. « To remove, reverse the above steps. « RF power will output from LOW-POWER £ TNC connector when "LOW" setting Is selected.
Proper AF (audio) Input and Connection « Combo jack connector accepts balanced (XLR) or unbalanced cable. « Proper input volume adjustment is needed after AF signal Is connected. « Three delectable AF levels can be selected from AF Level Switch £3 for optimal audio sensitivity. Exceeding Input volume will result In distortion for receiver AF output, and insufficient input volume will degrade the S/N ratio that increases higher background nose. Therefore, proper setting ensures optimal output audio quality.
