User's Manual

ManualsBrandsMipro Electronics ManualsAudio EquipmentHandheld Wireless Microphone

2 CE2 16

M R-80 1 a

OPERATINGMANUAL

ElectronicsCo.,Ltd.

Headoffice:814,Pei-KangRoad,Chiayi,60096,Taiwan.

Taipeioffice:5,Lane118,Sung-tehRoad,Taipei,Taiwan.

Web-http://www.mipro.com.tw

E-mail:@mipro.com.tw

11075,

mipro

Disposal

Disposetheunusabledeviceaccordingtovalidregulations.

Disposalofspentbatteries/accumulators

Youarerequiredbylawtoreturnallspentbatteries.

Disposingofusedbatterieswithdomesticwasteis

prohibited!

Batteries/NiCadcellscontainingtoxinsare

markedby

accompanyingsymbolsthatrefertothe

prohibitionof

disposalwithdomesticwaste.Thedesignations

forthe

decisiveheavymetalsare:=cadmium,

=mercury,

=lead.Youmayreturnspent

batteries/accumulatorsfree

ofchargetotherecyclingcentres,ouroutletsor

anywhere

elsewherebatteries/accumulatorsaresold.

Bydoingso,youfulfilthelegalrequirementsandcontribute

totheconservationofourenvironment!

2005-08-13

Half1 9 -inchunit

TrueDiversityWirelessMicrophoneSystem

Summary of content (9 pages)

PAGE 1
Disposal OPERATING MANUAL M R-80 1 a Dispose the unusable device according to valid regulations. Disposal of spent batteries/accumulators Half 1 9 -inch unit You are required by law to return all spent batteries. Disposingofusedbatteries with domesticwaste is prohibited! 2005-08-13 True Diversity Wireless Microphone System Batteries / NiCad cells containing toxins are marked by accompanying symbols that refer to the prohibition of disposal with domestic waste.
PAGE 2
TRUE DIVERSITY WIRELESS RECEIVER TRUE DIVERSITY WIRELESS RECEIVER Thank you for selecting MIPRO UHF half 19-inch unit true diversity wireless receiver system. Before operating please read this instruction manual carefully and thoroughly in order to attain the correct operatingprocedures and achieve thebestresults. B. Rear Panel 1 2 3 This system is divided into UHF single channel truediversity receiver with matching one microphones and individual volume controls.
PAGE 3
TRUE DIVERSITY WIRELESS RECEIVER TRUE DIVERSITY WIRELESS RECEIVER 2. INSTALLATION OF THE RECEIVER 1 2 3 1:GND 2:HOT + 3:COLD - A N T . B FCC C E MIC BALANCEDOUT UNBALANCEDOUT ANT.A LINE LEVEL SQ Fig.3 1. Install antenna in rear (6)(11) . Extend antenna to the fullest position. see fig. 3. 2.
PAGE 4
TRUE DIVERSITY WIRELESS RECEIVER TRUE DIVERSITY WIRELESS RECEIVER 4. 3. TWO 19/2-INCH UNITS RECEIVER INSTALLATION 1. Singlehalf-rack receiver (a) Push the rack mount ear optional accessory (FB-11) upwards until it is firmly attached to the receiver. (fig. 7) SIGNAL RF Make sure the system performs correctly, please place the system away from noise sources. Place the receiver atleast 1 meter above the ground and away from noise sources.
PAGE 5
TRUE DIVERSITY WIRELESS RECEIVER TRUE DIVERSITY WIRELESS RECEIVER 4. OPERATION INSTRUCTIONS 1. 5. Turn volume controls o f thereceiver andmixerin use to a minimumsetting beforeturn on the microphones or transmitters. After switches onthe receiver, the power switch red indicator illuminates to denotenormal power status. 1 2 3 1:GND 2:HOT + 3:COLD - ANT.B FCC CE MIC BALANCEDOUT Plugthe cable ofthe mains u nit into dc socket on the receiver'sback panel.
PAGE 6
NOTE HANDHELD WIRELESS MICROPHONE Latest modularized microphone structure. Built-in "NoiseLock" squelch circuitry eliminates "pop" interference. 1 2 3 4 5 6 7 (Fig.1) 1. PARTS NAMES AND FUNCTIONS 1. Grille: Protects cartridge and prevents "POP" noise. 2. Battery Status Indicator: Indicates power on / off and the battery status. When the power switch is turned ON, the red LEDs indicator flashes briefly, indicating normal battery status.
PAGE 7
BODYPACK TRANSMITTER BODYPACK TRANSMITTER 1. PARTS NAMES AND FUNCTIONS 2. BATTERY INSERTION 1 8 2 3 (Fig.2) 4 1. Unscrewbattery cap (6) in a counter-clockwise direction. 2. Inser two 1.5V(AA) battery into the battery compartment observing the correct polarity. The moment the battery touches the terminals of the compartment, the indicator will flash briefly . This means the polarity is correct. However, if no flashoccurs, this indicates wrong insertion or battery is dead.
PAGE 8
BODYPACK TRANSMITTER transmitting 3. AF 4-PIN INPUT CONNECTION METHODS 9. Detachable Belt Clip: Allows 360 degrees rotating to suittransmitting angles. To detach simply u s e a screwdriver at a 45 degree angle to unfasten. see diagram. 4 3 2 BATT. LOW PIN 1 SHIELD (Fig.2) 1 ON (1) 2-Wire Electret Condenser Microphone C apsule OFF 8. Transmitting Antenna: 1/ 4 λ antenna. BODYPACK TRANSMITTER AUDIO 2 4 1 3 2 3 2. OPERATING INSTRUCTIONS 4 1.
PAGE 9
BODYPACK TRANSMITTER NOTE 4. BATTERY INSTALLATION 1. Pushing down both snap locks on the sides o f battery cover to open battery cover. Take out the batteries. Fig.5). 2. Insert a two 1.5(AA) batteries into the battery compartment according to the correct polarityasshown in Fig. 5). Then push up to close the battery compartment as shown in Fig. 6). Notice : The changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.