User Guide GT-24 Guitar Transmitter All rights reserved. MN 015/05 Do not copy or forward without prior approvals MIPRO. Specifications and design subject to change without notice.
Guitar Transmitter Contents 1 Transmitter Controls and Indicators 3 Operating Instructions 6 Battery Insertion 7 MP-80 Battery Charger (Optional) Guitar Transmitter Transmitter Controls and Indicators 1 6 5 2 3 4 7 8 8 9 9 1 Housing: Holds internal PCB. 2 ACT Port: Align and sync frequency automatically with a matching receiver. 3 Battery Indicator Lights: Shows the battery level or charging status. 4 Power: Press and hold for 1~2 seconds to power on or off.
Guitar Transmitter Guitar Transmitter Operating Instructions 8 Battery Cover: Holds a single 18500 rechargeable battery. 9 Battery compartment & Battery: Inserts a single 18500 rechargeable battery according to correct polarity. Insert with plus (+) polarity end of battery towards inside of the battery compartment(see above graph). Wrong polarity insertion will result in no connection and will not damage the circuitry. 1. Power On & Off a. Press & hold for 1~2 seconds. b.
Guitar Transmitter 3. Ensure both the receiver and guitar transmitter frequencies are synchronized to the same channel and power is off on the guitar transmitter before inserting the plug into the electric guitar. Power on and adjust audio levels after plug insertion. 4 Guitar Transmitter 4. A suction cup holder can be installed manually for a secured fit for electric guitar/bass where the output jack is situated in different body area.
Guitar Transmitter Battery Insertion Guitar Transmitter MP-80 Battery Charger (Optional) 1. Gently push down on the battery compartment latch and swing the battery compartment door open (do not use force when opening or closing the battery door). GT-24 guitar transmitter and/or an additional 18500 recharge battery can be both recharged simultaneously in MP-80. GT-24 2. Install a freshly charged 18500 rechargeable battery with plus (+) polarity end of battery towards inside. 3.
Guitar Transmitter Guitar Transmitter Federal Communication Commission Interference Statement This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Guitar Transmitter Guitar Transmitter WARNING 1. FOR OUTDOOR USE: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. 2. UNDER WET LOCATION: Apparatus should not be exposed to dripping or splashing and no objects filled with liquids, such as vases should be placed on the apparatus. 3. SERVICE INSTRUCTIONS: CAUTION - These servicing instructions are for use by qualified service personnel only.
