User Manual Part 2

19
20
4. Cautions
1. Adjust the gain knob to the appropriate level (The gain level needs to be set
at 0dB level when using an electric guitar).
2. Plug the microphone connector into the AF input (1) and then secure the
connector by turning it in a clockwise direction, as shown in Fig. 4.
3. When the antenna has been removed, the body pack transmitter should
remain ''OFF'' to prevention future deterioration of signal transmission.
4. If the transmitter is on without any microphone connected to the AF input
socket, the system will clearly have noises of both high and low frequencies.
They will do no harm to the system, but will be annoying to the listener, so it
would be best to switch off the transmitter when disconnecting the
microphone.
BT BT BT BT BT
90% 80% 40% 10% 0%
BT
100%
DIGITAL WIRELESS BODY PACK TRANSMITTER
DIGITAL WIRELESS BODY PACK TRANSMITTER
7. BT: Displays Information of Battery Level
When the battery level drops down to 10%, please replace or recharge the
battery. If the battery continues to be used at a very lower level, the LCD will
display and then automatically switch off to avoid over-discharging the
battery.
"PO--OFF"
8. ERR: Error Code
ROM-ER Transmitter does not have the initial data so the
microphone is completely dead.
ERROR1 Failure on RF circuitry, frequency can not be
programmed.
NO----O3 Frequency to be programmed into the transmitter
exceeds its highest frequency of designated frequency
band of the transmitter.
NO----O4 Frequency to be programmed into the transmitter
exceeds its lowest frequency of designated frequency
band of the transmitter.
(9) PO-OFF: System Turning Off
When the power is turned off, the LCD displays ''PO-OFF''
indicating the system is at the state of shutting down and then
automatically cuts the power off. The display panel has no further
message afterward.
If the LCD displays ''ERR'' after turning on the power, it indicates the
operation is not correct. The error codes are as follows:
**NOTE:
NO----OR3 and NO----OR4 will not change transmitter's original frequency, and the
transmitter still operates normally with error message on display.. To remove error
message from display panel, please switch off the transmitter and switch it on again.
Lavalier
Headset
Capsule Connector
The ridge on the
connector must match the
indentation on the socket
when inserting.
(Fig.4)