User Manual Part 1

**NOTE: When program a special frequency via monitoring software;
LCD screen cannot display the number. This is because this special
channel is not in the preset group and channel. Therefore, LCD panel
will look like illustration below.
**NOTE: To modify transmitter's group, channel and frequency, all
three must be set at the receiver and transmit the new setting to
transmitter via ACT.
5
6
(1)GR-CH: Displays Information of Group and Channel
RF
RF
AF
AF
BT
BT
RF
RF
AF
AF
BT
BT
5
B. Operation Guide:
B. Operation Guide:
a. Press ''MODE'' and stop on "GR-CH" function, the display showing current group
and channel will be flashing. After 5 seconds, the display will stop flashing.
b. "GR-CH" function is added to display group and channel information. Changing
current group and channel must be done on the receiver.
GR--CH
MODE
5
a. Press ''MODE'' and stop on "FREQ" function, the display showing current
frequency will be flashing. After 5 seconds, the display will stop flashing.
B. "FREQ" function is added to display frequency information. Changing current
frequency must be done on the receiver.
(2) FREQ: Displays Information of Transmitter Frequency
RF
AF
BT
RF
AF
BT
5
FREQ
MODE
"MHz"
(3) LOW-CU: Setup and Change of Low Frequency Cut Off
a. Press ''MODE'' and stop on "LOW-CU" function, the display showing current state
will be flashing and is ready to be modified.
b. Press ''SET'' button to change to ''ON'' or ''OFF'' as desired.
SET OFF
SET ON
RF RF
AF AF
BT BT
RF
AF
BT
5
LOW--CU
MODE
ON
OFF
SET
A. Operate via MODE Button
A. Operate via MODE Button
B. Operation Guide:
A. Operate via MODE Button
**NOTE: When the LOW-CU function is ''ON'', the frequency response
below 100Hz will decrease about 4dB with a slope of -6dB/Octave.
DIGITAL WIRELESS HANDHELD MICROPHONE
DIGITAL WIRELESS HANDHELD MICROPHONE