User Manual Part 1

Fully Lit VFD Display
4. LCD Panel Functions
()
2. Battery Removals and Installation
Open the upper grille and capsule module, then turning the battery pack
in a counterclockwise direction in order to replace the battery (see diagram 2).
To reinstall the battery module after loading the new battery, turn it in a
clockwise direction (see diagram 2).
**NOTE: When microphone is not in use, please turn the power off.
Battery pack can be recharged while in the transmitter or remove
from transmitter and charged alone.
3
4
3. Rear Cap On/Off Switch Protection
The patented color rear cap serves two purposes, provides easy channel
identification and protecting the toggle on/off switch. It allows the on/off switch
to either be exposed or concealed as desired. You can avoid unintended
switching off of the microphone by rotating the color rear cap 180 degrees to
cover the on/off switch completely.
**Note: When using the microphone, the color rear cap must be in place.
A
RF
AF
B
BT
Mode Switch: To select from different menu
Function Selection:
The LCD panel has 6 functions displayed sequentially; their respective
descriptions and operations are as follows:
a. Press MODE (7) to access the 6 different functions. Once a function is selected, it
starts flashing on the screen. If parameter needs to be modified on selected
function, press SET (8) to modify the value while the display is still flashing. Once
done, leave it for 5 seconds until it stops flashing and the selection will be
programmed into the transmitter.
A. Operation Guide
FREQ LOW--CU
AF--SEN
LIMIT ENCRYPGR--CH
OPEN LOCK
180
DIGITAL WIRELESS HANDHELD MICROPHONE
DIGITAL WIRELESS HANDHELD MICROPHONE