User Manual Part 2

7
8
(5) LIMIT: Setup and Change of Input Limit
(6) ENCRYP: Displays Information of Encryption
SET OFF
SET ON
RF RF
AF AF
BT BT
RF
AF
BT
5
B. Operation Guide:
a. Press "MODE" and stop on "LIMIT" function, the display showing current state will
be flashing and is ready to be modified.
b. Press ''SET'' to change the setting to "ON" or "OFF".
A. Operate via MODE Button
LIMIT
MODE
ON
OFF
SET
(4) AF-SEN: Setup and Change of Input Sensitivity
SET 6dB
RF RF
AF AF
BT BT
RF
AF
BT
5
AF--SEN
MODE
0 DB
SET
6 DB
SET
12 DB
SET
0 dB 6 DB 12 DB
B. Operation Guide:
A. Operate via MODE Button
ENCRYP
MODE
ON
OFF
a. Press "MODE" and stop on "ENCRYP" function, the display showing current state
will be flashing.
A. Operate via MODE Button
B. Operation Guide:
a. Press "MODE" and stop on "AF-SEN" function, the display showing current state
will be flashing and is ready to be modified.
b. Every push of ''SET'' button, the dB value increases by 6dB to a maximum of
12dB.
**NOTE:
1. The higher the gains are set, the lower the dynamic range for signal input.
Meanwhile the danger of unwanted noises and feedback getting into the system would
obviously rise.
2. It is advisable to generally set the sensitivity to a level between 0dB-6dB.
3. When set at 0 dB, the maximum SPL for handheld microphone is 145dB.
**NOTE: When the LIMIT is ''ON'', the maximum output of the receiver is limited to 1V.
**NOTE: "ENCRYP" function is added to display status information only. Changing of
current status must be done from receiver via ACT.
DIGITAL WIRELESS HANDHELD MICROPHONE
DIGITAL WIRELESS HANDHELD MICROPHONE