User's Manual

Disposal
20 0 5-0 8 -1320 0 5-0 8 -13
Dispose of any unusable devices or batteries
responsibly and in accordance with any
applicable regulations.
Disposing of used batteries with domestic
waste is to be avoided!
Batteries/NiCad cells often contain heavy
metals such as cadmium(Cd), mercury(Hg)
and lead(Pb) that makes them unsuitable for
disposal with domestic waste. You may return
spent batteries/accumulators free of charge to
recycling centers or anywhere else
batteries/accumulators are sold.
By doing so, you contribute to the
conservation of our environment!
10 11
4. Furthermore, a large-diaphragm directional microphone
has a very distinct proximity effect. When the
microphone is close to the mouth, the bass response is
strengthened as the distance gets closer. RF, if a
performer's sound is insufficient in bass, they can hold
the microphone closer and use the proximity effect to
help compensate for the lower bass level. Conversely, if
a performer's voice is too heavy in the bass register,
increasing the distance between the microphone and
their mouth will decrease the proximity effect and
reduce the bass response, thus making their voice
become clearer and brighter.
5. It is recommended to keep the grille and sponge
windscreen clean to avoid any substance blocking the
proximity effect of the microphone.
Handheld Transmitter Handheld Transmitter
THIS DEVICE COMPLIES WITH PART 15 & 74 OF THE FCC RULES
AND RSS-123 ISSUE 2, RSS-210 ISSUE 8 OF CANADA.
OPERATION IS
SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1) This device may not cause interference.
(2) This device must accept any interference, including
interference that may cause undesired operation of the
device. This equipment complies with FCC RF radiation
exposure limits set forth for an uncontrolled environment.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
& IC - ID