User's Manual

ManualsBrandsMipro Electronics ManualsElectronicsTransmitter

Table Of Contents

MP-80 Charger charges both transmitters and

18500 rechargeable batteries.

MP-80 Battery Charger (Optional)

Transmitters Charging

18500 Charging

Transmitters Charging

Notes

1. Refer to actual product in the event of product

description discrepancy.

2. Frequency range and maximum deviation comply

with the regulations of different countries.

TransmitterTransmitter

Federal Communication Commission Interference

Statement

This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15

of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and

can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause

harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be

determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one of

the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and

receiver.

Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician

for help.

FCC Caution: To assure continued compliance, any

changes or modifications not expressly approved by the

party responsible for compliance could void the user's

authority to operate this equipment. (Example - use only

shielded interface cables when connecting to computer or

peripheral devices).

FCC Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure

limits set forth for an uncontrolled environment. This

equipment should be installed and operated with a

minimum distance of 0.5 cm between the radiator and your

body.