User's Manual

ManualsBrandsMipro Electronics ManualsElectronicsTransmitter

Personal Wireless Public Address SystemPersonal Wireless Public Address System

NOTE: Receiver channel selection can be set-up manually, too.

Press and hold 'SCAN” button for 1 second. Current channel blinks.

During blinking, press, hold and stop “SCAN” until the desired channel.

Repeat Automatic “Transmitter” Sync steps.

Turn on Power Switch / Volume Control . Red light should illuminate.

Turn on wireless transmitter. Green light should illuminate if there is RF link.

Adjust volume level clockwise to desired loudness.

One wireless microphone can simultaneously transmit to multiple MA-202 units

receiving on the same frequency for a wider and expanded coverage.

Multiple wireless microphones of the same frequency cannot transmit to an MA-202

receiver on that same frequency. For example, if you have both a hand-held wireless

microphone and a body-pack transmitter on the same frequency, be sure to switch off

one of the two to avoid severe interference between them!

Connect a line-level source, such as portable cassette/CD/MP3 player into the Aux

input jack .

Turn on the PA system and adjust volume as desired.

Hand Carrying:

Shoulder Carrying:

Mic Stand Mounting:

Remove the shoulder belt and store in the Battery Compartment

directly above the battery. Use the Fixed Handle for transport.

Remove the shoulder belt from the Battery Compartment and

hook the connector around the rod on top of the unit, between the Fixed Handle and the

Speaker.

The MA-202 will fit directly on top of a microphone stand using the

threaded mount with no additional hardware. Simply align the hole with the

protruding end of the mic stand and thread it on the stand.

Turn on Power Switch / Volume Control . Red light should illuminate.

Plug a wired microphone into the Mic In Jack . Turn on the Wired Microphone

Volume Control .

Turn clockwise for desired loudness.

The MA-202 allows simultaneous usage of both wired and wireless microphones.

Please make sure the built-in rechargeable batteries are fully charged before and after

use. The battery itself will gradually self-discharge over a long period of time.

Therefore, if the system will not be used for a long period of time, please make sure

the batteries are fully charged before storing them properly. The Company warranty

DOES NOT applies to over-discharged batteries; hence, please ensure the batteries are

recharged every 3 months.

Simply plug the connector of the supplied DC adapter to the DC 18V Power Input Jack

, and plug the other end into any available AC socket.

Battery will re-charge itself once plugged-in regardless if the system is turned on or

off.

Charging begins immediately, and will be indicated by a flashing LEDs. If the LEDs are

not flashing, it may due to excessive power over-drain and it may take longer for the

LEDs to flash. This is normal and not faulty. If, after a while, there is still no flashing

LEDs, the rechargeable battery may be faulty.

If a battery replacement is needed, open the battery compartment and exchange the

faulty battery for a new one. Be sure to insert the battery with the right polarity

connection.

The battery is an expendable item. Under normal operation, MIPRO offers a one-year

limited warranty.

If you experience a short operating time after the batteries are fully charged, it is

often an indication of aging batteries. Therefore, the rechargeable battery should be

replaced as soon as possible at your earliest convenience.

PERSONAL WIRELESS PA SYSTEM AUXILIARY INPUT

INSTALLATION METHODS:

WIRED MICROPHONE INSTRUCTIONS:

MA-202 BATTERY CHARGING PROCEDURES

OPERATING INSTRUCTIONS