User Manual

1 x Splash Holder

2. Power and Operation
There are two types MIOPS Splash and the old version works with battery but the new version works
from a USB power source.
New Version:
Your MIOPS Splash comes with Micro USB power cable so you can attach it to any USB power
source to turn it on.
Old Version:
MIOPSSplash operates with a single 23A (12V Alkaline) battery. It is important that you use
acompatible battery only. Otherwise, you may damage the unit. You can change the battery by
removing 4 screws on the back side of the device.
In order to change the battery, turn it o rst. Then remove the four Philips screws. Then youcan
take the bottom cover apart from the unit.You can remove the battery with a at headscrewdriver.
Be careful not to damage anycomponent on the board. Put the fresh battery inby observing the
battery polarity
3. First Use
Your MIOPS Splash maynot be delivered with the latest rmware. If a new rmware has been
released, before you have used it for the rst time, youshould update the rmware rst. To get
detailed information about the rmware upgrade, see the Firmware Upgrade Section.
When you attach your MIOPS Splash to any USB power source, the LED willblink with short
intervals and the device will start to work.
4. Camera and Flash Connection
The MIOPS Splash uses connection cables to trigger your camera or ash unit. Your unit will be
shipped with a ash cable. You should purchase a camera cable separately if you need to trigger
your camera. The MIOPS Splash is a versatile device, which is compatible with many brand and
models. You can use the same device with many dierent cameras by just changing the connection
cable.
The MIOPS Splash has separate outputs for the camera and ash cables. The camera cable port is a
   
Home Products

Support SHOP Blog Contact Explore
