User Manual

Please check your firmware and app versions to verify the reference of this document.
4.3.4 Laser Mode
The laser mode is used is to capture picture of moving items. This can be a wild
animal, a bird or a ball rolling down. In order to use this mode, you need a laser
source. You will feed the laser beam to MIOPS and whenever the beam is broken
MIOPS will trigger your camera or flash unit. The type of the laser source is not
important. It can be a red or green laser source. The laser beam must be stabilized
so it does not move away from the receiver of MIOPS. The receiver of MIOPS is on
the front side of the device. Attention: Laser beam can be dangerous. Avoid
eye contact. Use the laser source at your own risk. We strongly recommend
that you use a protective goggle.
The laser mode has three different
parameters. These are Threshold,
Delay and Frame. The threshold
value is used to determine the
minimum power of the laser source
required to activate the mode. If
you are using a low power laser
source, you can set the threshold to
a low value. The second parameter
is the delay. It works the same way
as in other modes. It adds the
adjusted delay in milliseconds. The
third parameter is the frame. This
parameter determines how many
pictures to be taken after the laser
beam is broken. You can set the
frame number anywhere between 1
up to 999.