User manual

13
en
> System > Storage Allocation to set a proper allocation for parking recording.
Changing the allocation will erase the memory card so save any videos or photos to your
computer first.

When the Parking mode detection is enabled the system will enter Parking mode when
you:
- disconnect the device's power (e.g. the vehicle engine is stopped or the power cable
is disconnected) or when the car stops moving for about 5 minutes*; or
- press to manually start Parking mode while continuous recording is in progress.
* The feature is triggered by the G sensor of the device. You can change the configuration
by selecting > Parking Mode > Auto Entry.

To stop Parking mode and resume continuous recording, press .

If movements were detected and recorded during Parking mode you will be asked to
playback the video when you stop Parking mode.

The parking recordings can be found in the “Parking” category for file playback.
Camera mode

The recorder allows you to take a photo.
- If the recording is in progress, press to take a photo*.
- Press > Camera > .
* This function is not available when the rear camera is connected.

The photos can be found in the “Photo” category for file playback.