Operation Manual

1.2 Setting Up Your Pocket PC for Use

Performing Initial Startup

Initial startup includes installing the battery, setting the backup battery switch

and completing the Welcome Wizard.

1. Slide the battery lock to the unlock (

) position () and then open the

battery door ().

2. Insert the projected parts of the battery into the battery compartment ()

and then fit the battery into place ().

NOTE:

To remove the battery, first push the battery downward and then pull it out at an

angle.

3. The backup battery switch should be set to the ON

(right) position for normal operation. Pull out the

stylus and use it to slide the battery switch to the ON

(right) position.

CAUTION: Always leave the backup battery switch in the ON

position for normal operation. Changing the switch will cause

your data to be lost.

4. Replace the battery door and slide the battery lock to

the lock (

) position.

NOTE: If the battery door is not closed, you cannot turn on your

Pocket PC.