User manual

5
Getting started
Charging the battery Your device has an internal battery that may not be fully charged when you purchase it. You should charge the battery for at least 8 hours before you start using it for the very first time. To charge the battery, use the supplied USB cable to connect the device to a computer, USB charger or power adapter.
CAUTION: For optimal performance of the lithium battery, note the following: • Do not charge the battery where the temperature is high (e.g. in direct sunlight). • Failure to follow the battery usage instructions could cause damage to your device,
battery and even bodily injury or property damage and will void the warranty.
• When storing the product for a long period of time, charge the battery to 50% –
80% capacity to prevent excess discharge.
Performing the initial start-up 1. Mount the device and accessories on to your bike. For more information, see
the “Installing the device” section.
2. Press and hold the POWER button for 3 seconds to turn your device on.
3 SEC
3. Follow the prompts to personalise your device, including:
• Select your preferred language.
• Set the date and time. • Set the units format. • Create your user profile. Note: You can change these settings while using the device by tapping Main menu > Settings.
4. Activate the map.
Enter the Startup Key (which is printed on the bottom of the box) and then tap OK to unlock your device. You will only have to do this the first time you use the device.
5. Once your device is turned on, it will search for satellite signals
automatically. This may take several seconds depending on the location. When GPS is fixed, the GPS signal icon ( ) on the screen indicates the GPS status. Note: Depending on your device model, it will also automatically scan and pair the accessories (for heart rate monitor and cadence/speed sensor only) with the device. You can also scan the accessories manually while using the device by tapping Main menu > Settings > Sensors.
Connecting your device to the computer 1. Turn on the computer. 2. Turn on your device. 3. Connect the Micro-USB end of the USB cable to the back of your device and
the other end to a USB port on your computer.
4. Select the desired connection type from the pop-up message window:
• Connect to PC: Your device will be recognised as two external mass-
storage drives: Mio_system and Mio_data. You can use Windows File Explorer to copy/move the files from the computer to your device. A USB Connection screen appears to prevent you from using your device. DO NOT delete any files that are pre-installed on the device. Deleting the files can cause the device to crash. Mio is not responsible for product quality caused by file deletion.
• Charge only: You will be able to continue using your device with the
battery in charging mode via the computer.