Specifications

3 www.everik.com BTH200.KM.072013.IM
Note: Pairing mode will last 2 minutes. If not devices can be connected aer 2 minutes, it will return to standby mode automacally.
5. Making calls
Funcon Status of BTH100 Operaon
Cancel calling Calling Press MFB buon once
Answer a call Incoming ring Press MFB buon once
Reject a call Incoming ring Press and hold MFB buon for 2 seconds and release it unl hearing
indicaon tone
End a call During a call Press MFB buon once
Volume up During a call
Press + buon
Volume down During a call
Press －button
Call transfer (cell phone to headset) During a call Press MFB buon for 2 seconds
Microphone mute During a call Double click MFB buon
Cancel mute During a call Double click MFB buon
Voice dial Standby mode and connected to a device Press < buon about 2 seconds and release it unl hear a prompt tone
Redial last number Standby mode and connected to a device Double click MFB buon
6. LED indicator
A. Charging
LED Indicator Status of headset
Red LED on Charging
Red LED o Finish Charging
B. Pairing with Bluetooth device
LED Indicator Status of headset
Red and blue LED ashes alternately Pairing mode
Blue LED ashes once quickly every 2 seconds Not connect device
Blue LED ashes twice quickly every 4 seconds Have already connected HFP or A2DP
Blue LED ashes three mes quickly every 4 seconds Connect HFP and A2DP simultaneously
Blue LED ashes quickly Calling/incoming call
Blue LED ashes once quickly every 4 seconds During a call
Red LED ashes twice every 30 seconds Low baery
7. Indicaon tone
Indicaon tone Status of the headset
Connuous two prompt tone every 10 seconds Conversaon mode and microphone mute
Three “dong” warning tone every 20 seconds Low baery
8. Factory Reset
In turned o mode, press and hold MFB and volume up “+” buon about 8 seconds, you will see red LED on 1 second and hear two tones.
 Aer factory reset, the paired list of devices will be deleted.