Specifications

2 www.everik.com BTH200.KM.072013.IM
1. Charging the headset
The headset comes with a built-in rechargeable baery, prior to using it, it is recommended to charge the baery fully for the rst me. When the headset is low
power, the headset emits “Dongdong” tones about every 20 seconds and the red LED ashes. Please recharge the baery of the headset.
How to charge the headset:
Plug USB charging cable into the USB port of computer and connect the micro connector to the headset
It will take about 3 hours to nish charging
 Red light on: Charging
 Red light o: Finished charging
2. Turning the headset on/o
Funcons Operaon LED indicator
Turning On Press and hold MFB buon for 4 seconds unl blue LED ashes Blue LED on one second
Turning O Press and hold MFB buon for 4 seconds unl red LED ashes Red LED on one second
Note: In order to save power, the headset will turn o automacally if no devices are connected aer 5 minutes.
3. Pairing the headset
Funcons Operaon LED indicator
Entering pairing mode Ensure the headset is o, and then press and hold the MFB buon for 7 to
8 seconds unl red and blue LED ash alternately
Red and blue LED ash alternately
3-1. Pairing the headset—Notes
Prior to using the headset for the rst me, you have to pair it with a Bluetooth-enabled device. The pairing procedures may dier pending on the model of the
device you’re trying to pair. Please refer to your device/phone user manual for further informaon.
The general pairing procedures are as follows:
 Keep your headset and phone within 1 meter when pairing;
 Start the pairing mode operaon on your headset (see #3 pairing headset)
 Acvate your device Bluetooth funcon and set your device to search for Bluetooth devices within range and select “BTH200” from the list of devices shown;
 Enter PIN/ Password No: “0000”( Note: If the mobile phone supports Bluetooth V2.1, password is not required.)
 If prompted by your device to connect, select “Yes”
 Aer successfully connecng, blue LED light on the headset ashes 2/3 mes every 4 seconds
Notes:
 If pairing failed, please turn o the headset rst and then re-pair according to steps 1-6 menoned above.
 Aer inial pairing, the headset and the device will remember each other, they will no longer need to re-pair next me. The headset can store up to 8 paired devices. When the
number of paired devices exceeds 8, the rst one will be replaced.
4. Playing Music
Funcons Status of the headset LED indicator
Volume up Playing music Press + buon
Volume down Playing music Press - buon
Rewind Playing music Press ◄ buon once
Fast forward Playing music Press ► buon once
Pause Playing music Press MFB once
Play Pausing music Press MFB once
When the headset connects to a mobile phone or Bluetooth transmier which supports A2DP, you can enjoy music wirelessly through the headset.