Instructions / Assembly

7. Apply second coat. If third coat is desired, repeat step 6 before
application.
8. After final coat, allow 24 hours before light use.
When used on hardwood floors, use a lambswool or synthetic pad applicator
or natural bristle brush and maintain a wet edge to avoid lap marks. For
maximum durability, we recommend three coats. Avoid heavy traffic and
replacing of furniture for 72 hours after final coat. When replacing furniture, do
not slide. Do not install rugs or clean floors for 7 days.
CLEANUP: Use mineral spirits or paint thinner following manufacturer’s safety
instructions.
.
COVERAGE: Approximately 125 square feet per quart.
Note: Above dry times are based on good ventilation, temperature of 77°F and
50% relative humidity. Lower temperature, higher humidity, lack of air
movement or application of thick coats will extend drying times. Always test
tackiness between coats. Do not sand or re-coat when surface is tacky. Slight
ambering may be experienced when Polyurethane is applied over light-
colored wood surfaces. Always spot test on an inconspicuous area to ensure
satisfactory results. For light-colored wood surfaces, we recommend
protecting with Minwax® Polycrylic® Protective Finish.
DANGER: Rags, steel wool, other waste soaked with this product,
and sanding residue may spontaneously catch fire if improperly
discarded. Immediately place rags, steel wool, other waste soaked
with this product, and sanding residue in a sealed, water-filled
metal container. Dispose of in accordance with local fire regulations.