Instructions / Assembly

ManualsBrandsMinwax ManualsInterior Stain1 gal. Semi-Gloss Fast-Drying Polyurethane (2-Pack)

Fast-Drying Polyurethane

(1 Gallon & 2.5 Gallon)

Directions

WARNING! Removal of old paint by sanding, scraping or other means may

generate dust or fumes that contain lead. Exposure to lead dust or fumes may

cause brain damage or other adverse health effects, especially in children or

pregnant women. Controlling exposure to lead or other hazardous substances

requires the use of proper protective equipment such as a properly fitted

respirator (NIOSH approved) and proper containment and cleanup. For more

information, call the National Lead Information Center at 1-800-424-LEAD (in

US) or contact your local health authority.

1. Surface must be dry and free of old finishes in poor condition, paint,

wax, grease, polish, dirt or other foreign matter.

2. Sand to obtain a smooth uniform surface. Remove all dust with a cloth

dampened with mineral spirits.

3. If desired, apply stain, such as Minwax® Wood Finish™ or Minwax®

Gel Stain to unfinished wood surfaces. Follow directions for application

and dry times.

4. Stir Minwax® Fast-Drying Polyurethane before and during use to

eliminate settling on the bottom of the can. Stir to rotate the product

from the bottom to the top of the can. NEVER SHAKE.

5. Apply a THIN coat of Minwax® Fast-Drying Polyurethane using a high-

quality natural or foam brush.

6. Let dry 4-6 hours. Then lightly sand entire surface with fine sandpaper

(220 grit) to ensure an even finish and proper adhesion. Remove all

dust.

Summary of content (3 pages)

PAGE 1
Fast-Drying Polyurethane (1 Gallon & 2.5 Gallon) Directions WARNING! Removal of old paint by sanding, scraping or other means may generate dust or fumes that contain lead. Exposure to lead dust or fumes may cause brain damage or other adverse health effects, especially in children or pregnant women. Controlling exposure to lead or other hazardous substances requires the use of proper protective equipment such as a properly fitted respirator (NIOSH approved) and proper containment and cleanup.
PAGE 2
7. Apply second coat. If third coat is desired, repeat step 6 before application. 8. After final coat, allow 24 hours before light use. When used on hardwood floors, use a lambswool or synthetic pad applicator or natural bristle brush and maintain a wet edge to avoid lap marks. For maximum durability, we recommend three coats. Avoid heavy traffic and replacing of furniture for 72 hours after final coat. When replacing furniture, do not slide. Do not install rugs or clean floors for 7 days.
PAGE 3
WARNING! COMBUSTIBLE! VAPOR HARMFUL. IRRITATES EYES, SKIN AND RESPIRATORY TRACT CAUTIONS: CONTAINS ALIPHATIC HYDROCARBONS Contents are COMBUSTIBLE. Keep away from heat and open flame. VAPOR HARMFUL. Use only with adequate ventilation. To avoid overexposure, open windows and doors or use other means to ensure fresh air entry during application and drying. If you experience eye watering, headaches, or dizziness, increase fresh air or wear respiratory protection (NIOSH approved) or leave the area.