SAFETY DATA SHEET 2716 Section 1. Identification Product name : MINWAX® WOOD FINISH® Dark Walnut : 2716 Product code Other means of : Not available. identification Product type : Liquid. Relevant identified uses of the substance or mixture and uses advised against Paint or paint related material.
Section 2. Hazards identification Hazard statements : Flammable liquid and vapor. Suspected of causing cancer. May be fatal if swallowed and enters airways. May cause respiratory irritation. May cause drowsiness or dizziness. Causes damage to organs through prolonged or repeated exposure. Precautionary statements General Prevention Response Storage Disposal Supplemental label elements : Read label before use. Keep out of reach of children.
Section 3. Composition/information on ingredients Ingredient name % by weight CAS number Light Aliphatic Hydrocarbon Heavy Naphthenic Petroleum Oil Aliphatic Solvent Med. Aliphatic Hydrocarbon Solvent 1,2,4-Trimethylbenzene Light Aromatic Hydrocarbons Mineral Spirits (Odorless) 1,3,5-Trimethylbenzene Carbon Black Cumene ≥25 - ≤50 ≥10 - ≤25 ≥10 - ≤25 ≤5 <1 <1 <1 ≤0.3 ≤0.3 ≤0.
Section 4. First aid measures Eye contact : No specific data. Inhalation : Adverse symptoms may include the following: respiratory tract irritation coughing nausea or vomiting headache drowsiness/fatigue dizziness/vertigo unconsciousness : No specific data.
Section 6. Accidental release measures Personal precautions, protective equipment and emergency procedures For non-emergency personnel : No action shall be taken involving any personal risk or without suitable training. Evacuate surrounding areas. Keep unnecessary and unprotected personnel from entering. Do not touch or walk through spilled material. Shut off all ignition sources. No flares, smoking or flames in hazard area. Avoid breathing vapor or mist. Provide adequate ventilation.
Section 7. Handling and storage Conditions for safe storage, including any incompatibilities : Store in accordance with local regulations. Store in a segregated and approved area. Store in original container protected from direct sunlight in a dry, cool and well-ventilated area, away from incompatible materials (see Section 10) and food and drink. Store locked up. Eliminate all ignition sources. Separate from oxidizing materials. Keep container tightly closed and sealed until ready for use.
Section 8. Exposure controls/personal protection Cumene 98-82-8 OSHA PEL (United States, 5/2018). TWA: 3.5 mg/m³ 8 hours. ACGIH TLV (United States, 3/2019). TWA: 50 ppm 8 hours. NIOSH REL (United States, 10/2016). Absorbed through skin. TWA: 50 ppm 10 hours. TWA: 245 mg/m³ 10 hours. OSHA PEL (United States, 5/2018). Absorbed through skin. TWA: 50 ppm 8 hours. TWA: 245 mg/m³ 8 hours.
Section 8. Exposure controls/personal protection 8 hrs OEL: 50 ppm 8 hours. 8 hrs OEL: 246 mg/m³ 8 hours. CA British Columbia Provincial (Canada, 5/2019). TWA: 25 ppm 8 hours. STEL: 75 ppm 15 minutes. CA Ontario Provincial (Canada, 1/2018). TWA: 50 ppm 8 hours. CA Quebec Provincial (Canada, 1/2014). TWAEV: 50 ppm 8 hours. TWAEV: 246 mg/m³ 8 hours. CA Saskatchewan Provincial (Canada, 7/2013). STEL: 74 ppm 15 minutes. TWA: 50 ppm 8 hours.
Section 8. Exposure controls/personal protection Hand protection Body protection Other skin protection Respiratory protection : Chemical-resistant, impervious gloves complying with an approved standard should be worn at all times when handling chemical products if a risk assessment indicates this is necessary. Considering the parameters specified by the glove manufacturer, check during use that the gloves are still retaining their protective properties.
Section 10. Stability and reactivity Reactivity : No specific test data related to reactivity available for this product or its ingredients. Chemical stability : The product is stable. Possibility of hazardous reactions : Under normal conditions of storage and use, hazardous reactions will not occur. Conditions to avoid : Avoid all possible sources of ignition (spark or flame). Do not pressurize, cut, weld, braze, solder, drill, grind or expose containers to heat or sources of ignition.
Section 11. Toxicological information Mutagenicity Not available. Carcinogenicity Not available. Classification Product/ingredient name OSHA IARC NTP Carbon Black Cumene - 2B 2B Reasonably anticipated to be a human carcinogen. Reproductive toxicity Not available. Teratogenicity Not available. Specific target organ toxicity (single exposure) Name Category Route of exposure Target organs Light Aliphatic Hydrocarbon Category 3 Category 3 Not applicable. Not applicable.
Section 11. Toxicological information Name Result Light Aliphatic Hydrocarbon Aliphatic Solvent Med.
Section 11. Toxicological information Developmental effects : No known significant effects or critical hazards. Fertility effects : No known significant effects or critical hazards. Numerical measures of toxicity Acute toxicity estimates Not available. Section 12.
Section 13. Disposal considerations Disposal methods : This product contains a Significant New Use Rule (SNUR) Chemical. Do not allow this product to enter drains, sewers, wastewater treatment systems, groundwater, streams, lakes or ponds. See Environmental Data Sheet (EDS) for additional details. The generation of waste should be avoided or minimized wherever possible.
Section 14. Transport information regulated as hazardous materials. ERG No. ERG No. ERG No. 128 128 128 Special precautions for user : Multi-modal shipping descriptions are provided for informational purposes and do not consider container sizes. The presence of a shipping description for a particular mode of transport (sea, air, etc.), does not indicate that the product is packaged suitably for that mode of transport.
Section 16. Other information The customer is responsible for determining the PPE code for this material. For more information on HMIS® Personal Protective Equipment (PPE) codes, consult the HMIS® Implementation Manual. Caution: HMIS® ratings are based on a 0-4 rating scale, with 0 representing minimal hazards or risks, and 4 representing significant hazards or risks. Although HMIS® ratings and the associated label are not required on SDSs or products leaving a facility under 29 CFR 1910.
Date of issue/Date of revision 2716 : 3/11/2020 MINWAX® WOOD FINISH® Dark Walnut Date of previous issue : 3/3/2020 Version : 22.