SAFETY DATA SHEET 2750 Section 1. Identification Product name : MINWAX® WOOD FINISH® Jacobean : 2750 Product code Other means of : Not available. identification Product type : Liquid. Relevant identified uses of the substance or mixture and uses advised against Paint or paint related material.
Section 2. Hazards identification Hazard statements : Flammable liquid and vapor. Suspected of causing cancer. May be fatal if swallowed and enters airways. May cause respiratory irritation. May cause drowsiness or dizziness. Causes damage to organs through prolonged or repeated exposure. Precautionary statements General Prevention Response Storage Disposal Supplemental label elements : Read label before use. Keep out of reach of children.
Section 3. Composition/information on ingredients Ingredient name % by weight CAS number Light Aliphatic Hydrocarbon Heavy Naphthenic Petroleum Oil Aliphatic Solvent Med. Aliphatic Hydrocarbon Solvent 1,2,4-Trimethylbenzene Mineral Spirits (Odorless) Light Aromatic Hydrocarbons Carbon Black 1,3,5-Trimethylbenzene Xylene, mixed isomers Cumene Hydrotreated Heavy Petroleum Naphtha ≥25 - ≤50 ≥10 - ≤25 ≥10 - ≤25 ≤5 <1 <1 <1 ≤0.3 ≤0.3 ≤0.3 ≤0.3 ≤0.
Section 4. First aid measures Ingestion : Can cause central nervous system (CNS) depression. May be fatal if swallowed and enters airways. Over-exposure signs/symptoms Eye contact : No specific data. Inhalation : Adverse symptoms may include the following: respiratory tract irritation coughing nausea or vomiting headache drowsiness/fatigue dizziness/vertigo unconsciousness : No specific data.
Section 6. Accidental release measures Personal precautions, protective equipment and emergency procedures For non-emergency personnel : No action shall be taken involving any personal risk or without suitable training. Evacuate surrounding areas. Keep unnecessary and unprotected personnel from entering. Do not touch or walk through spilled material. Shut off all ignition sources. No flares, smoking or flames in hazard area. Avoid breathing vapor or mist. Provide adequate ventilation.
Section 7. Handling and storage Conditions for safe storage, including any incompatibilities : Store in accordance with local regulations. Store in a segregated and approved area. Store in original container protected from direct sunlight in a dry, cool and well-ventilated area, away from incompatible materials (see Section 10) and food and drink. Store locked up. Eliminate all ignition sources. Separate from oxidizing materials. Keep container tightly closed and sealed until ready for use.
Section 8. Exposure controls/personal protection Xylene, mixed isomers 1330-20-7 Cumene 98-82-8 Hydrotreated Heavy Petroleum Naphtha 64742-48-9 TWA: 25 ppm 10 hours. TWA: 125 mg/m³ 10 hours. ACGIH TLV (United States, 3/2019). TWA: 100 ppm 8 hours. TWA: 434 mg/m³ 8 hours. STEL: 150 ppm 15 minutes. STEL: 651 mg/m³ 15 minutes. OSHA PEL (United States, 5/2018). TWA: 100 ppm 8 hours. TWA: 435 mg/m³ 8 hours. ACGIH TLV (United States, 3/2019). TWA: 50 ppm 8 hours. NIOSH REL (United States, 10/2016).
Section 8. Exposure controls/personal protection CA Alberta Provincial (Canada, 6/2018). 8 hrs OEL: 3.5 mg/m³ 8 hours. CA Quebec Provincial (Canada, 1/2014). TWAEV: 3.5 mg/m³ 8 hours. CA Saskatchewan Provincial (Canada, 7/2013). STEL: 7 mg/m³ 15 minutes. TWA: 3.5 mg/m³ 8 hours. CA Alberta Provincial (Canada, 6/2018). 8 hrs OEL: 100 ppm 8 hours. 15 min OEL: 651 mg/m³ 15 minutes. 15 min OEL: 150 ppm 15 minutes. 8 hrs OEL: 434 mg/m³ 8 hours. CA British Columbia Provincial (Canada, 5/2019).
Section 8. Exposure controls/personal protection Appropriate engineering controls Environmental exposure controls : Use only with adequate ventilation. Use process enclosures, local exhaust ventilation or other engineering controls to keep worker exposure to airborne contaminants below any recommended or statutory limits. The engineering controls also need to keep gas, vapor or dust concentrations below any lower explosive limits. Use explosion-proof ventilation equipment.
Section 9. Physical and chemical properties Melting point/freezing point : Not available. Boiling point/boiling range : 148°C (298.4°F) Flash point : Closed cup: 41°C (105.8°F) [Pensky-Martens Closed Cup] Evaporation rate : 0.13 (butyl acetate = 1) Flammability (solid, gas) : Not available. Lower and upper explosive (flammable) limits : Lower: 1% Upper: 8.8% Vapor pressure : 0.17 kPa (1.27 mm Hg) [at 20°C] Vapor density Relative density Solubility : 5 [Air = 1] : 0.85 : Not available.
Section 11. Toxicological information Product/ingredient name Result Species Heavy Naphthenic Petroleum LD50 Oral Oil 1,2,4-Trimethylbenzene LC50 Inhalation Vapor LD50 Oral Light Aromatic Hydrocarbons LD50 Oral Carbon Black LD50 Oral 1,3,5-Trimethylbenzene LC50 Inhalation Vapor LD50 Oral Xylene, mixed isomers LC50 Inhalation Gas.
Section 11. Toxicological information Reproductive toxicity Not available. Teratogenicity Not available. Specific target organ toxicity (single exposure) Name Category Route of exposure Target organs Light Aliphatic Hydrocarbon Category 3 Category 3 Not applicable. Not applicable. Aliphatic Solvent Category 3 Category 3 Not applicable. Not applicable. Med. Aliphatic Hydrocarbon Solvent Category 3 Category 3 Not applicable. Not applicable. 1,2,4-Trimethylbenzene Category 3 Not applicable.
Section 11. Toxicological information Name Result Light Aliphatic Hydrocarbon Aliphatic Solvent Med.
Section 11. Toxicological information Mutagenicity : No known significant effects or critical hazards. Teratogenicity : No known significant effects or critical hazards. Developmental effects : No known significant effects or critical hazards. Fertility effects : No known significant effects or critical hazards. Numerical measures of toxicity Acute toxicity estimates Not available. Section 12.
Section 12. Ecological information Mobility in soil Soil/water partition coefficient (KOC) : Not available. Other adverse effects : No known significant effects or critical hazards. Section 13. Disposal considerations Disposal methods : This product contains a Significant New Use Rule (SNUR) Chemical. Do not allow this product to enter drains, sewers, wastewater treatment systems, groundwater, streams, lakes or ponds. See Environmental Data Sheet (EDS) for additional details.
Section 14. Transport information Additional information This product may be re-classified as "Combustible Liquid," unless transported by vessel or aircraft. Non-bulk packages (less than or equal to 119 gal) of combustible liquids are not regulated as hazardous materials. ERG No. Product classified as per the following sections of the Transportation of Dangerous Goods Regulations: 2.18-2.19 (Class 3). The environmentally hazardous substance mark may appear if required by other transportation regulations.
Section 15. Regulatory information Vietnam inventory: Not determined. Section 16. Other information Hazardous Material Information System (U.S.A.) * Health 3 Flammability 2 Physical hazards 0 The customer is responsible for determining the PPE code for this material. For more information on HMIS® Personal Protective Equipment (PPE) codes, consult the HMIS® Implementation Manual.
Section 16. Other information It is recommended that each customer or recipient of this Safety Data Sheet (SDS) study it carefully and consult resources, as necessary or appropriate, to become aware of and understand the data contained in this SDS and any hazards associated with the product. This information is provided in good faith and believed to be accurate as of the effective date herein. However, no warranty, express or implied, is given.