Safety Data Sheets (SDS)

Section 8. Exposure controls/personal protection
Glass
65997-17-3
NIOSH REL (United States, 10/2016).
TWA: 3 f/cc 10 hours.
TWA: 3 f/cc 10 hours. Form: Fibers of spec
length
TWA: 5 mg/m³ 10 hours. Form: Total
ACGIH TLV (United States, 3/2020).
TWA: 5 mg/m³ 8 hours. Form: Inhalable
fraction
TWA: 1 f/cc 8 hours. Form: Respirable fibers:
length greater than 5 uM; aspect ratio equal to
or greater than 3:1 as determined by the
membrane filter method at 400-450X
magnification (4-mm objective) phase contrast
illumination.
Propylene Glycol
57-55-6
AIHA WEEL (United States, 7/2018).
TWA: 10 mg/m³ 8 hours.
Chlorallyl-Hexaminium Chloride
4080-31-3
None.
Ingredient name
Exposure limits
Hand protection
Chemical-resistant, impervious gloves complying with an approved standard should be
worn at all times when handling chemical products if a risk assessment indicates this is
necessary. Considering the parameters specified by the glove manufacturer, check
during use that the gloves are still retaining their protective properties. It should be
noted that the time to breakthrough for any glove material may be different for different
glove manufacturers. In the case of mixtures, consisting of several substances, the
protection time of the gloves cannot be accurately estimated.
Safety eyewear complying with an approved standard should be used when a risk
assessment indicates this is necessary to avoid exposure to liquid splashes, mists,
gases or dusts. If contact is possible, the following protection should be worn, unless
the assessment indicates a higher degree of protection: safety glasses with side-
shields.
Eye/face protection
:
:
Emissions from ventilation or work process equipment should be checked to ensure
they comply with the requirements of environmental protection legislation. In some
cases, fume scrubbers, filters or engineering modifications to the process equipment
will be necessary to reduce emissions to acceptable levels.
Appropriate engineering
controls
:
Good general ventilation should be sufficient to control worker exposure to airborne
contaminants.
Wash hands, forearms and face thoroughly after handling chemical products, before
eating, smoking and using the lavatory and at the end of the working period.
Appropriate techniques should be used to remove potentially contaminated clothing.
Contaminated work clothing should not be allowed out of the workplace. Wash
contaminated clothing before reusing. Ensure that eyewash stations and safety
showers are close to the workstation location.
Hygiene measures
:
Individual protection measures
Skin protection
None.
Ingredient name
Exposure limits
Occupational exposure limits (Canada)
Environmental exposure
controls
:
None.
Exposure limits
Occupational exposure limits (Mexico)
CAS #
CAS #
CAS #
Date of issue/Date of revision
:
10/14/2020
Date of previous issue
:
5/1/2020
Version
:
6
5/12
448-
MINWAX® Color-Changing Wood Filler
SHW-85-NA-GHS-US