SDS

Section 2. Hazards identification
Prevention
:
Obtain special instructions before use. Do not handle until all safety precautions have
been read and understood. Use personal protective equipment as required. Wear
protective gloves. Wear eye or face protection. Keep away from heat, hot surfaces,
sparks, open flames and other ignition sources. No smoking. Use explosion-proof
electrical, ventilating, lighting and all material-handling equipment. Use only non-
sparking tools. Take precautionary measures against static discharge. Keep container
tightly closed. Use only outdoors or in a well-ventilated area. Do not breathe vapor.
Wash hands thoroughly after handling.
Response
:
Get medical attention if you feel unwell. IF exposed or concerned: Get medical
attention. IF INHALED: Remove victim to fresh air and keep at rest in a position
comfortable for breathing. Call a POISON CENTER or physician if you feel unwell. IF
SWALLOWED: Immediately call a POISON CENTER or physician. Do NOT induce
vomiting. IF ON SKIN (or hair): Take off immediately all contaminated clothing. Rinse
skin with water or shower. IF ON SKIN: Wash with plenty of soap and water. Take off
contaminated clothing. If skin irritation occurs: Get medical attention. IF IN EYES:
Rinse cautiously with water for several minutes. Remove contact lenses, if present and
easy to do. Continue rinsing. If eye irritation persists: Get medical attention.
Storage
:
Store locked up. Store in a well-ventilated place. Keep cool.
Disposal
Dispose of contents and container in accordance with all local, regional, national and
international regulations.
General
:
Read label before use. Keep out of reach of children. If medical advice is needed, have
product container or label at hand.
Hazards not otherwise
classified
:
None known.
Please refer to the SDS for additional information. Do not transfer contents to other
containers for storage.
Supplemental label
elements
Adequate ventilation required when sanding or abrading the dried film. If Adequate
ventilation cannot be provided wear an approved particulate respirator (NIOSH
approved). Follow respirator manufacturer's directions for respirator use. DELAYED
EFFECTS FROM LONG TERM OVEREXPOSURE. Abrading or sanding of the dry film
may release crystalline silica which has been shown to cause lung damage and cancer
under long term exposure. DELAYED EFFECTS FROM LONG TERM
OVEREXPOSURE. Contains solvents which can cause permanent brain and nervous
system damage. Intentional misuse by deliberately concentrating and inhaling the
contents can be harmful or fatal. WARNING: This product contains chemicals known to
the State of California to cause cancer. FOR INDUSTRIAL USE ONLY. This product
must be mixed with other components before use. Before opening the packages, READ
AND FOLLOW WARNING LABELS ON ALL COMPONENTS.
Section 3. Composition/information on ingredients
Styrene
13.0
100-42-5
Ingredient name
CAS number
% by weight
There are no additional ingredients present which, within the current knowledge of the supplier and in the
concentrations applicable, are classified as hazardous to health or the environment and hence require reporting
in this section.
Other means of
identification
:
Not available.
Substance/mixture
CAS number/other identifiers
:
Occupational exposure limits, if available, are listed in Section 8.
Mixture
Date of issue/Date of revision
:
4/6/2015.
Date of previous issue
:
No previous validation.
Version
:
1
2/12